Now I'm able to ping anything I want from the router only. Use dnsmasq instead of udhcpd (should be default these days) When services stop working, localize them as close as possible. (And enjoy the availability of ssh access! it would be much harder without) ping an IP (66.249.85.99, - resolve a hostname (ping Work your way down the chain.
(from a PC connected to your downlink, as well as from the downlink router itself) With the firewall set up properly (default should be sufficient) you should be able to Log in (ssh) into the downlink router, and check /tmp/dnsmasq for valid nameserver entries. Re-establish the connection to get a clean state. Have your "uplink" router run DHCP, and hand out 192.168.1.xxx addresses.Ĭonfigure your "downlink" router to DHCP on the WAN interface (and of course connect its WAN to a LAN port of the uplink). No idea what to change other then the gateway or router option. Can anyone point me in the right direction?īefore, I just selected automatic confiiguration in internet setup and changed the ip to 192.168.2.1 on the old WRT firmware. I've been reading through the wiki but can't seem to find any info regarding it. Just have to find out how to use it as a wired AP off my other router now. i had to go back to the v23final to get my ports back no one has replyed back to my thread yet 5 a day to try to get my lan ports working. Make sure you have it connected to the affected routerĮdit: i tried flashing back to the linksys firmware and i spend. My other WRT handles my PPPoE, this is wired to the DD-WRT witch is getting a ip of 192.168.1.100 sees my DNS servers etc, but not pushing anything outside through.īeen working on this all day as you might be able to tell.Ĭhange your network card to 192.168.1.20 see if you can ping either 192.168.1.250 or 192.168.1.245 Now I have it configed to be 192.168.2.1 and using router option. Tryed a hard reboot (hold reset down and power unit on) that gave me wan and ethernet ports to work. I tryed to "upgrade" to the linksys firmware. "So you tried to use the computer and it started smoking? Sounds like a Mac to me." - Louis Rossmann but dd-wrt works up to now on any WRT unit from linksys flawlessly Sounds like you bricked your unit in any way (dont be afraid its recoverable)
Else, I'm office spacing this and put a post it note on my other WRT NOT TO install DD-WRT!!! So, I'm going to try and find a linksys firmware to go back to if I can ever get back into the interface.
So just getting to the web interface is hard. Now, it seems like the wireless end is on off. Computer and or router never see the physical connection.
0 kommentar(er)
